The main component of outdoor signage repair is the base of metal spray paint. For minor scratches and paint defects, local repair paint technology can be used on-site at outdoor signage. The procedure is as follows:
A Polish. Either by hand or with a sander, first use slightly coarser sandpaper and then finer sandpaper to smooth it.

B Clean. Use a lint-free cloth dipped in thinner and give a quick wipe. Be careful not to touch the cleaned surface.
C Mix the catalyst and pigment. Mix hardener and paint according to manufacturer's instructions. Use too much hardener and the paint will become too slippery and brittle, while paint with too little hardener will not apply properly and will fade easily. Mix the appropriate amount each time and use it within two hours.

D paint finish. Depending on the number of surfaces to be painted, use a paint brush, roller tool, or spray bottle. Pointillism techniques are often used to match the original texture. The best construction temperature is from 18℃ to 30℃. After 3 hours of construction, the paint will go through the stages of surface drying and actual drying. Under normal circumstances, it can be completely dry in 2 to 3 days.
E Reprocessing. If the base surface of an outdoor signage is extensively damaged, the entire base should be returned to the factory for repainting. Contact signage manufacturer for video guidance and reprocessing NPS hardware guidance.

F Replacement. Considering factors such as time, budget, project management, brand image upgrade and environment, sometimes it is better to "replace" rather than "repair" the signage base. A new outdoor signage base will add cost, so take the old one back to your local scrap metal recycling center.




